Features
Wear Edge Technology™
Westfield developed Wear Edge Technology™ to extend the life of the flighting. This provides an extra layer of steel welded to the edge on critical wear points. As a result, flighting lasts longer and needs to be replaced less often – saving time and money.
Powder Coat Paint
Westfield uses a durable powder coat paint for a strong, long lasting finish that looks good and protects against rust.
A-Frame Undercarriage
The MKX Series features an A-frame undercarriage to withstand bowing and maintain rigid alignment during heavy loads.
Low Profile Hopper
The low profile hopper features left and right hand flighting to pull grain toward the center of the hopper so it flows efficiently up into the tapered boot – maximizing capacity and minimizing unload time.
Optional Features
- Low profile hopper
- LED working lights
- Transport lights
- Right angle drive
- Speed reducer-reverser kit
- Reverser kit
Specs
| MODEL | MKX10-83 |
| TUBE GAUGE | 12 GA |
| TUBE CONNECTORS | Heavy-Duty ³/16" (0.5cm) Angle Flange |
| MAIN FLIGHTING | 9" (22.9cm) OD x 7 GA Stretched and Welded with Wear Edge Technology™ at Critical Points |
| WEAR EDGE TECHNOLOGY (REINFORCED FLIGHT)" |
¼" (0.6cm) plus 10 GA Ribbon Weld = 5 /16" (0.8cm) Wear Edge Technology™ on Critical Grain Transfer Points |
| FLIGHTING SHAFT | High Strength 2" (5.1cm) OD x 11 GA Tubing Square Flight Connection |
| UPPER BEARING | 1 ¼" (3.2cm) Pillow Block Greaseable Ball Bearing |
| LOWER BEARING | 1 ½" (3.8cm) Pillow Block Greaseable Ball Bearing |
| TUBE TRUSSING | ³/8" (1cm) Aircraft Type Galvanized Steel Cable |
| HYDRAULIC LIFT | One 4 ½" (11.4cm) Cylinder with ³/8" (1cm) Aircraft Cable |
| UNDERCARRIAGE | 3 ½" (8.9cm) x 11 GA A-frame |
| AXLE | 3 ½" (8.9cm) x 3 ½"" (8.9cm) x ³/16"" (0.5cm) Wall Square Tubing |
| HUB | Heavy-Duty 6-Bolt Iron Hubs |
| TIRES | 16" (40.6cm) |
| PTO SHAFT | 35E Constant Velocity with 5 /16" (8mm) Shear Bolt |
| PARKING JACK | 2000 lbs. (907.2 kg) Side Wind |
| SPROCKET & CHAIN | Hardened Tooth Sprocket with #60 Chain |
| LOW PROFILE HOPPER DIMENSIONS | 63" Length (160cm) x 40" Width (101.6cm) x 10.5" Height (26.7cm) |
| PSI REQUIRED TO RAISE AUGER | 1800 PSI (124.1 bar) |
| HP REQUIRED (WITH DRY WHEAT) | 75 HP (55.9 kW) |
| WHEEL TREAD | 112" - 144" (2.8m - 3.7m) |
| TRANSPORT HEIGHT | 12' 8" (3.9m) |
Copyright © 2026 - All Rights Reserved - EquipmentLocator.com